
TNVI V3 Installation Guide ( Setup For Handphone / Laptop )
TYPE C & IPhone to Audio Jack Converter is not Included in the package !
Please Get ORIGINAL Accesories or Get it From Us !
B) OPPO/REALME USER PLEASE TAKE NOTE ***
Default Audio Recorder
Go to [Settings] > [Sound & Vibration] > [Default Audio Recorder] > Choose [Add-on]. After selecting Add-on, the device will start recording audio from external mic attached to your phone.
🎉Problems that may be encountered in use:
A. If the LED Light Blinking on RX or TX
1. Try to charge the device, Low battery signal LED will Blink
2. UHF Signal not pairing, Please Refer above B Step to Sync/Pairing the Signal
B. Take a video without sound
1. After Recording Video , Please Remove the RX Receiver , then only can listen back the voice
2, OPPO User Need to some setting on their phone, Please refer above C
C. Why I talk no sound come out ??
This microphone is a receiver, not an amplifier or Speaker, If you want to amplified or listen you voice instant, please connect to the external speaker
How to Sync Channel of TNVI V3 TX & RX (Do This IF your Device is Blinking Not Pairing )
** Take Note ** PLEASE DONT DO THIS IF YOU DEVICE NOT BLINKING ****
V3配对方法步骤 ** 你的麦克风灯没有闪,请不需要做这步骤 **
1、接收机关机(RX)
2、打开发射机(TX),长按住加减键出现蓝灯闪烁时松开
3、再打开接收机, 按开关键俩次
4、再短按发射机(TX)的加键,这时发射机和接收机蓝灯常亮表示配对成功
V3 Signal Pairing ** Take Note ** PLEASE DONT DO THIS IF YOU DEVICE NOT BLINKING ****
1. Please Turn off the Receiver (RX)
2. Turn ON The Transmitter (TX), Press and Hold Volume + & - Button Until the LED Light Blinking
3. Turn ON the Receiver Now (RX) >> Double click the power button ( the light will stable now)
4. Then Press The Volume + Once Time , Now You will See Both Device LED Light is Stable. Pairing Successful